Logo

P2181 Engine Code Repair

Meaning of P2181 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P2181 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P2181 code is occuring now you should check P2181 repair processes.
Now don't ask yourself; What should you do with P2181 code ?
The solution is here :

P2181 Possible Solution:

P2181 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P2181 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

2
Fuel And Air Metering (Injector Circuit Malfunctions Only)

1
Ambient Air Temperature Sensor Circuit Low

8
Cylinder 10 Contribution/balance Fault

1
Shift Solenoid E Performance or Stuck Off

Regarding the P2181 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P2181 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P2181 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For P2181 Code

The reason of P2181 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

P2181 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.